Teg Tab FAQ

Can Teg-Tab’s be made in different colours?
Yes on request, please note minimum quantities and lead times apply.

Can Teg-Tab’s be used on an angle?
Definitely! Teg-Tab’s are designed to allow for a 45 degree angle.

Can Teg-Tab’s be used on wall molding that is 22mm?
Yes, match-up your grid and tile sizes and use any of the Teg Tab options.

Can Teg-Tab’s be used under seismic restrictions?
When used with the Armstrong BERC or USG ACM7 clip, the Teg-Tab becomes essentially cosmetic and is not subject to seismic load requirements. Only when used IN PLACE of a seismic clip, requiring rivets, are Teg-Tabs subject to seismic code requirements. Read the report on Seismic Capacity testing.

Must Teg-Tabs be riveted in place?
No, Teg-Tabs snap into place and stay in place. Riveting may be necessary for seismic code requirements, in which case, rivet right through the tab. When used with the Armstrong BERC or USG ACM7 clip, the Teg-Tab becomes essentially cosmetic and is not subject to seismic load requirements. Only when used IN PLACE of a seismic clip, requiring rivets, are Teg-Tabs subject to seismic code requirements.

Are Teg-tab’s fire rated?
Definitely, check how they perform under these conditions

Where can I purchase Teg-Tabs?
Teg Tabs are available at our authorised distributors listed below:

Can I get Teg-Tab samples?
Sure. Complete this form and we’ll set you up.